Days until

Made with wood and unisub board

1 small piece measures 4x2

6 large pieces measures 6.25x2

The stand measures approx. 8.5x6.5

The specific time and temperature settings for sublimating a Unisub board can vary based on factors like the type of substrate, the type of sublimation ink, and the specific heat press being used. However, here's a general guideline:

1. **Preheat**: Preheat your heat press to around 380-400°F (193-204°C).

2. **Prepare the Board**: Clean the Unisub board surface to remove any dust or debris.

3. **Place Your Design**: Position your sublimation print face down on the board, ensuring it's centered and aligned correctly.

4. **Pressing Time**: Press the board for approximately 50-60 seconds.

5. **Pressing Pressure**: Apply medium to firm pressure, depending on your heat press's capabilities.

6. **Cooling and Finishing**: Once the pressing is complete, carefully remove the Teflon sheet and the sublimation paper. Allow the board to cool completely before handling it.

7. **Quality Check**: Inspect the board for any imperfections or areas where the transfer may not have adhered properly.

8. **Finalize**: If everything looks good, your Unisub board should now be sublimated and ready for display or use!

Always refer to the specific instructions provided by Unisub or your sublimation ink supplier for the best results with their products.

Please allow up to 5 days to process your order

These are cut in house